Airworthiness Directives; Airbus Helicopters

<RULE> DEPARTMENT OF TRANSPORTATION <SUBAGY>Federal Aviation Administration</SUBAGY> <CFR>14 CFR Part 39</CFR> <DEPDOC>[Docket No. FAA-2025-1737; Project Identifier MCAI-2025-01210-R; Amendment 39-23113; AD 2025-17-03]</DEPDOC> <RIN>RIN 2120-AA64</RIN> <SUBJECT>Airworthiness Directives; Airbus Helicopters</SUBJECT> <HD SOURCE="HED">AGENCY:</HD> Federal Aviation Administration (FAA), DOT. <HD SOURCE="HED">ACTION:</HD> Final rule; request for comments. <SUM> <HD SOURCE="HED">SUMMARY:</HD> The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model AS332L, AS 332L1, AS 332L2, and EC 225LP helicopters. This AD was prompted by a report of a corroded emergency sea anchor pin. This AD requires inspecting the emergency sea anchor and, depending on the result, replacing the emergency sea anchor. The FAA is issuing this AD to address the unsafe condition on these products. </SUM> <EFFDATE> <HD SOURCE="HED">DATES:</HD> This AD is effective September 8, 2025. The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of September 8, 2025. The FAA must receive comments on this AD by October 6, 2025. </EFFDATE> <HD SOURCE="HED">ADDRESSES:</HD> You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods: • <E T="03">Federal eRulemaking Portal:</E> Go to <E T="03">regulations.gov</E> . Follow the instructions for submitting comments. • <E T="03">Fax:</E> (202) 493-2251. • <E T="03">Mail:</E> U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590. • <E T="03">Hand Delivery:</E> Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. <E T="03">AD Docket:</E> You may examine the AD docket at <E T="03">regulations.gov</E> under Docket No. FAA-2025-1737; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this final rule, the mandatory continuing airworthiness information (MCAI), any comments received, and other information. The street address for Docket Operations is listed above. <E T="03">Material Incorporated by Reference:</E> • For European Union Aviation Safety Agency (EASA) material identified in this AD, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; phone: +49 221 8999 000; email: <E T="03">ADs@easa.europa.eu;</E> website: <E T="03">easa.europa.eu.</E> You may find the EASA material on the EASA website at <E T="03">ad.easa.europa.eu.</E> • You may view this material at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Parkway, Room 6N-321, Fort Worth, TX 76177. For information on the availability of this material at the FAA, call (817) 222-5110. It is also available at <E T="03">regulations.gov</E> under Docket No. FAA-2025-1737. <FURINF> <HD SOURCE="HED">FOR FURTHER INFORMATION CONTACT:</HD> David Enns, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: (316) 946-4147; email: <E T="03">david.enns@faa.gov.</E> </FURINF> <SUPLINF> <HD SOURCE="HED">SUPPLEMENTARY INFORMATION:</HD> <HD SOURCE="HD1">Comments Invited</HD> The FAA invites you to send any written data, views, or arguments about this final rule. Send your comments using a method listed under the <E T="02">ADDRESSES</E> section. Include “Docket No. FAA-2025-1737; Project Identifier MCAI-2025-01210-R” at the beginning of your comments. The most helpful comments reference a specific portion of the final rule, explain the reason for any recommended change, and include supporting data. The FAA will consider all comments received by the closing date and may amend this final rule because of those comments. Except for Confidential Business Information (CBI) as described in the following paragraph, and other information as described in 14 CFR 11.35, the FAA will post all comments received, without change, to <E T="03">regulations.gov</E> , including any personal information you provide. The agency will also post a report summarizing each substantive verbal contact received about this final rule. <HD SOURCE="HD1">Confidential Business Information</HD> CBI is commercial or financial information that is both customarily and actually treated as private by its owner. Under the Freedom of Information Act (FOIA) (5 U.S.C. 552), CBI is exempt from public disclosure. If your comments responsive to this AD contain commercial or financial information that is customarily treated as private, that you actually treat as private, and that is relevant or responsive to this AD, it is important that you clearly designate the submitted comments as CBI. Please mark each page of your submission containing CBI as “PROPIN.” The FAA will treat such marked submissions as confidential under the FOIA, and they will not be placed in the public docket of this AD. Submissions containing CBI should be sent to David Enns, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590. Any commentary that the FAA receives which is not specifically designated as CBI will be placed in the public docket for this rulemaking. <HD SOURCE="HD1">Background</HD> EASA, which is the Technical Agent for the Member States of the European Union, has issued EASA Emergency AD 2025-0146-E, dated July 10, 2025 (EASA AD 2025-0146-E) (also referred to as “the MCAI”), to correct an unsafe condition on Airbus Helicopters Model AS 332 L, AS 332 L1, AS 332 L2, and EC 225 LP helicopters. The MCAI states a report was received of a corroded emergency sea anchor pin. An emergency sea anchor pin with extreme corrosion could cause the anchor pin to break and release the emergency sea anchor in flight, which could result in damage to the rotors and consequent loss of control of the helicopter. You may examine the MCAI in the AD docket at <E T="03">regulations.gov</E> under Docket No. FAA-2025-1737. <HD SOURCE="HD1">Material Incorporated by Reference Under 1 CFR Part 51</HD> The FAA reviewed EASA Emergency AD 2025-0146-E, which specifies procedures for a one-time inspection of the emergency sea anchor for corrosion and, depending on the results, replacing the emergency sea anchor with a serviceable part. This material is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the <E T="02">ADDRESSES</E> section. <HD SOURCE="HD1">FAA's Determination</HD> These products have been approved by the civil aviation authority of another country and are approved for operation in the United States. Pursuant to the FAA's bilateral agreement with this State of Design Authority, that authority has notified the FAA of the unsafe condition described in the MCAI referenced above. The FAA is issuing this AD after determining that the unsafe condition described previously is likely to exist or develop on other products of the same type design. <HD SOURCE="HD1">AD Requirements</HD> This AD requires accomplishing the actions specified in EASA AD 2025-0146-E, described previously, except for any differences identified as exceptions in the regulatory text of this AD. <HD SOURCE="HD1">Interim Action</HD> The FAA considers that this AD is an interim action. This unsafe condition is still under investigation by the manufacturer and, depending on the results of that investigation, the FAA might consider further rulemaking action. <HD SOURCE="HD1">Explanation of Required Compliance Information</HD> In the FAA's ongoing efforts to improve the efficiency of the AD process, the FAA developed a process to use some civil aviation authority (CAA) ADs as the primary source of information for compliance with requirements for corresponding FAA ADs. The FAA has been coordinating this process with manufacturers and CAAs. As a result, EASA AD 2025-0146-E is incorporated by reference in this AD. This AD requires compliance with EASA AD 2025-0146-E in its entirety through that incorporation, except for any differences identified as exceptions in the regulatory text of this AD. Using common terms that are the same as the heading of a particular section in EASA AD 2025-0146-E does not mean that operators need comply only with that section. For example, where the AD requirement refers to “all required actions and compliance times,” compliance with this AD requirement is not limited to the section titled “Required Action(s) and Compliance Time(s)” in EASA AD 2025-0146-E. Material referenced in EASA AD 2025-0146-E for compliance will be available at <E T="03">regulations.gov</E> under Docket No. FAA-2025-1737 after this AD is published. <HD SOURCE="HD1">Justification for Immediate Adoption and Determination of the Effective Date</HD> Section 553(b) of the Administrative Procedure Act (APA) (5 U.S.C. 551 <E T="03">et seq.</E> ) authorizes agencies to dispense with notice and comment procedures for rules when the agency, for “good cause,” finds that those procedures are “impracticable, unnecessary, or contrary to the public interest.” Under this section, an agency, upon finding good cause, may issue a final rule without providing notice and seeking comment prior to issuance. Further, section 553(d) of the APA authorizes agencies to make rules effective in less than thirty days, upon a finding of good cause. An unsafe condition exists that requires the immediate adoption of this AD without providing an opportunity for public comments prior to adoption. The FAA has found that the risk to the flying public justifies forgoing notice and comment prior to adoption of this rule because corrosion could cause cracks to develop quickly and without warning, ━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━ Preview showing 10k of 20k characters. Full document text is stored and available for version comparison. ━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━